Installation And Operating Instructions; Symbols Used In This Document; Applications - Grundfos CIM 500 Montage- Und Betriebsanleitung

English (GB) Installation and operating instructions
Original installation and operating instructions
CONTENTS
1. Symbols used in this document
2. Applications
2.1 Abbreviations
2.2 CIM 500 Ethernet module
3. Installation
3.1 Connecting the Ethernet cable
3.2 Selection of industrial Ethernet protocol
3.3 Setting up the IP addresses
3.4 Connection to the web server
4. Status LEDs
5. Data activity and link LEDs
6. Fault finding
6.1 Modbus TCP/BACnet IP
6.2 PROFINET IO
6.3 GRM IP
7. Technical data
8. Service
8.1 Service documentation
9. Disposal
Warning
Prior to installation, read these installation
and operating instructions. Installation and
operation must comply with local
regulations and accepted codes of good
practice.

1. Symbols used in this document

Warning
If these safety instructions are not
observed, it may result in personal injury.
If these safety instructions are not
Caution observed, it may result in malfunction or
damage to the equipment.
Notes or instructions that make the job
Note
easier and ensure safe operation.
4

2. Applications

The CIM 500 Ethernet module enables data
transmission between an industrial Ethernet network
Page and a Grundfos product.
The module supports various industrial Ethernet
4
protocols. See section
4
Ethernet protocol.
5
The module is fitted in the product to be
5
communicated with or in a CIU 500.
6
Retrofitting of the module is described in the
installation and operating instructions of the
6
Grundfos product.
7
Configuration is done via the built-in web server,
7
using a standard web browser on a PC.
7
See the specific functional profile on the DVD
8
supplied with the Grundfos product.
9
10
10
12
14
15
15
15
15
3.2 Selection of industrial