Herunterladen Inhalt Inhalt Diese Seite drucken

Bringing Into Use; Connecting The Compressed Air Source; Using The Tyre Inflator Gauge; Using The Blow Gun - Parkside PDSS A1 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 43

Bringing into use

Bringing into use
Q
Connecting the
Q
compressed air source
NOTE: Operate the product only with cleaned, conden-
sate- and oil-free compressed air and never exceed the
maximum working air pressure at the device of 8 bar.
NOTE: The compressed air source must be fitted
with a (filter) / pressure reducer so that the air pres-
sure can be regulated.
j
C onnect the product to a suitable compressed air
source by connecting the quick-release coupling
of the air supply hose with the plug-in nipple
the product. It locks itself in place automatically.

Using the tyre inflator gauge

Q
1. Place the valve connector
Schrader valve
(e.g. often used on mountain bikes)
2. Press the trigger
6
3. Release the trigger
Read off the filling pressure on the gauge
4. If the object is overfilled with air (air pressure
too high): Press the deflator valve
some air.
5. Press the lever of the valve connector
wards and pull the valve connector
valve.
6. After you finish work, disconnect the device
from the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.
8
GB
4
on to the valve.
5
to start the delivery of air.
to stop the delivery of air.
6
1
to release
3
down-
5
off the
5
Using accessories:
j
P ress the lever of the valve connector
insert the desired accessory
cap
into the valve connector
9
to
Presta valve, e.g. cycle tyre valve
2
Dunlop valve, traditional cycle tyre valve
TIP: Use the valve adapter
valves shown.

Using the blow gun

Q
1. Screw an extension nozzle
gun
.
7
.
2. Press the trigger
3. Release the trigger
4. After you finish work, disconnect the device
from the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.
5
to
or the
10
13
.
5
for the cycle tyre
13
7
on to the blow
8
to start the delivery of air.
6
to stop the delivery of air.
6
and

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis