RIKA Look RLU Montageanleitung Seite 34

Mounting
Set the wooden bench as desired. The holes are symmetrical, you can turn
around the bench and set the seat part right or left.
First, plug the plinth panel, then the 4 spacers on the preassembled screws on
the stove.
Fasten the parts with the enclosed threaded sleeves.
Lay the heat shield on the wooden bench, hole on hole.
Mounting support E15768
Insert the two „handles" in the top flue outlet so that the lower bending faces
outward.
Now insert the two spacers between them so that they engage with the tabs
into the slots.
Now the position of the two handles is fixed.
Put a stable rod or a square timber through the two openings. The stove can
now be lifted. A third person should lead the bottom of the stove to find the
correct position on the basement.
Note
Do not use round rods or tubes, only rods with a flat contact surface. Risk of
slipping! Pay attention to the simultaneous lifting.
Now unscrew the transportation construction from the stove.
#10
Note
Warning, the stove is no longer secured against tipping!
Lift the stove careful and set it on the bench with the threaded sleeves into the
holes.
Screw the hexagonal bolts and washers from the bottom into the threaded
sleeves. The stove is now secured.
Insert the glass plate in the lower shelf to protect the wooden surface. Put the
quiver for the fire irons into the provided hole.
Note
A base is required (glass, sheet steel or ceramic) in front of the wooden bench
if the floor is combustible.
#8
#13