Features; Operation Notes - CombiSteel VDB-80S Gebrauchsanweisung

Thank you for selecting our Automatic Ice Flake Machine!
To ensure the proper operation of this ice flaker, please read the instruction carefully before use and
please keep it for inspection in case troubles occur.

Computerized control , easy operation & high reliability

Stainless steel exterior

Bell shaped clear ice

Self-malfunction analysis

If water shortage or something wrong with the water supply system, the Ice Flake Machine will restart
automatically in 24hours otherwise you will stop the unit and restart it again.

PU foamed ice storage cabinet ,so it is insulated well and it could prevent the ice from melting

High Efficiency , low power consumption

Use fresh water to make clear and healthful ice
1. The incline angle of the cabinet could not be over 45 °C during transportation.
Don't make ice flaker upside-down in case the compressor or refrigerating system
troubles occur.
2. When the ice flaker will be used for the first time or reused after let it lie idle for
a long time, drainage screw should be unscrewed and a container should be
placed under it to receive wasted water. The first and second ice making cycles
are just for tube system cleaning, the ice made should not be taken. After the water drained and
drainage screw is screwed, the normal ice making procedures will begin and you can take the ice.
3. The ice flaker should be placed on horizontal and structurally sound ground and away
from heat source and corrosive gas. At least about 150mm room should be left
around the ice maker to ensure the fine ventilation.
4. Please adjust the feet when placing the ice maker somewhere, otherwise the water
level will be effected and so do the ice shape. Before using the ice maker for the first
time, you should wait about 12 hours after positioning it in a proper place.
5. The outlet of drainage tube should be lower than cabinet so as to drain water easily.
6. Voltage range: 187 ~ 242 V
7. The rated capacity of wire should be over 6A, the section area of the wire is
0.75mm2. The wire could be consisted by single ply or multiplies. The rated
current of fuse is 5A.
8. The grounding must be good.

FEATURES

OPERATION NOTES

3