Herunterladen Inhalt Inhalt Diese Seite drucken

Features; Operation Notes - CombiSteel VDB-90 Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Thank you for selecting our Automatic Ice Cube Maker!
To ensure the proper operation of this ice maker, please read the instruction carefully before use
and please keep it for inspection in case troubles occur.
Computerized control , easy operation & high reliability
Stainless steel exterior
Bell shaped clear ice
Self-malfunction analysis
If water shortage or something wrong with the water supply system, the Ice Cube Maker will restart
automatically in 24hours otherwise you will stop the unit and restart it again.
PU foamed ice storage cabinet ,so it is insulated well and it could prevent the ice from melting
High Efficiency , low power consumption
Use fresh water to make clear and healthful ice
1. The incline angle of the cabinet could not be over 45 °C during transportation.
Don't make ice maker upside-down in case the compressor or refrigerating system
troubles occur.
2. When the ice maker will be used for the first time or reused after let it lie idle for
a long time,drainage screw should be unscrewed and a container should be
placed under it to receive wasted water. The first and second ice making cycles
are just for tube system cleaning, the ice made should not be taken.After the water drained and
drainage screw is screwed, the normal ice making procedures will begin and you can take the ice.
3. The ice maker should be placed on horizontal and structurally sound ground and
away from heat source and corrosive gas. At least about 150mm room should be left
around the ice maker to ensure the fine ventilation.
4. Please adjust the feet when placing the ice maker somewhere, otherwise the water
level will be effected and so do the ice shape. Before using the ice maker for the first
time, you should wait about 12 hours after positioning it in a proper place.
5. The outlet of drainage tube should be lower than cabinet so as to drain water easily.
6. The grounding must be good.
7. Don't take down the Block Water Board when the ice maker is running.
8. When the water out of one or more Spray Nozzle is weaken, you should clean the Spray Nozzle then put
it back. Screw the screw cap on the Spray Nozzle, then pull out the Spray Nozzle with a plier.
9. We advise that install a water filter in the water input.
10. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
11. WARNING: fill with potable water only
Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
This appliance is intended to be used in household and similar applications such as:
staff kitchen areas in shops, offices and other working environments;
farm houses and by clients in hotels, motels and other residential type environments;
catering and similar non-retail applications.

FEATURES

OPERATION NOTES

3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis