Motorola PMLN6481 Bedienungsanleitung Seite 6

Mounting the Adjustable Angle Bracket
Once an installation location has been decided, refer to
Figure 2 and perform the following steps:
1. Verify that the selected mounting surface is strong
enough to support the mounting hardware and handset.
2. Use the base of the adjustable angle bracket as a
template to center punch and drill four 3.2 mm (0.136")
diameter holes. Be careful not to damage any wires or
any other vehicle components when drilling the holes.
3. Use the four 8-18 x 3/4" tapping screws and the internal
lockwashers provided to mount and secure the bracket.
4. Place the hang-up cup on top of the bracket mounting
surface and secure it using the four M4 x 6 mm
machine screws and lockwashers provided.
5. Select the angle between the two bases of the
adjustable angle bracket (from 0° to 110°) and tighten
the two adjusting screws.
.
Bend tabs to
fit mounting
surface
contour
Hand Screw
(each side)
Bracket
Base
Adjusting Angle
0° to 110°
Internal Star
Lockwasher (4)
Figure 2 Adjustable Angle Bracket
Machine Screw (4)
M3.5 x 0.6 x 20 mm
Locking Hex Nut (4)
M3.5 x 0.6 mm
4
Tapping Screw (4)
M4 x 22 mm