Philips HB952 Handbuch Seite 20

ENGLISH
20
Problem
The appliance does not start
The fuse cuts off the power when you
switch on the tanning appliance or
during use.
Poor tanning capacity
The appliance cannot be put back into
transport position.
Possible cause
The plug has not been (properly) inserted into the wall socket.
There is a power failure. Check by means of an other appliance.
The lamps are still too hot to go on. Let them cool down for 3 minutes first.
The appliance was not sufficiently cooled and the overheating protection
switched the appliance off automatically. Remove the cause of overheating
(e.g. remove a towel that is blocking one or more vents).Wait for 10 minutes
and switch the appliance back on.
The two lamp units have not been put in the right position (see 'Preparing
for use').
Check the fuse of the circuit to which the tanning appliance is connected.The
correct fuse type is a 16A standard fuse or an automatic fuse.The fuse may
also blow because you have connected too many appliances to the same
circuit.
You are using an extension cord that is too long and/or does not have the
correct rating (16A). Consult your dealer. Our general advice is not to use an
extension cord.
You are not following the tanning schedule suitable for your skin type.
The distance between the lamps and the surface you lie on is larger than
prescribed.
When the lamps have been used for a long time, the UV emitted will
decrease.This effect only becomes noticeable after several years.You can
solve this problem by selecting a longer tanning time or by having the lamps
replaced. After 750 operating hours an L will appear on the display telling you
that it is advisable to have the lamps replaced.
You have not pushed the upper part of the appliance backward far enough.
Make sure you first push the upper part backward before pushing it down
(see 'Storing').
The appliance fails to unlock automatically. In that case you first have to press
unlocking button (B), after which you can fold the appliance back into its
transport position in the manner indicated in the chapter 'Storing'. If the
appliance fails to unlock several times, contact your dealer or a Philips Service
Centre.