Philips HB952 Handbuch Seite 15

After the tanning session
C
1 Keep track of the number of sessions you have had by means
of the memory knobs (type HB953 only).The appliance has
two memory knobs: one for each person.
Cooling
The appliance is cooled by means of fans to prevent materials and
parts from becoming too hot.The tanning lamps won't go on if they
are too hot (see for instance "Interrupting the tanning session").
After you have switched off the tanning lamps, the fans will
continue to work for three more minutes.
This is convenient, because it enables you to use the tanning lamps
again only 3 minutes after switching them off.
If you have switched the tanning appliance off by removing the plug from
B
the wall socket, the fans won't provide cooling for three more minutes, of
course.
If you have switched the tanning appliance off by removing the plug from
B
the wall socket and another person wishes to use the appliance for a
tanning session right away, the newly set time won't blink on the display.
This means that the next person will have to keep track of the three-
minute cooling-down period himself.
Cleaning
1 Always unplug the appliance and let it cool down before you
start cleaning it.
2 Clean the outside of the appliance with a damp cloth.
Do not let any water run into the appliance.
3 Do not use any scouring agents or scouring pads.
Never use abrasive liquids like scouring agents, petrol or acetone to
clean the appliance.
You can clean the outside of the UV filters with a soft cloth
sprinkled with some methylated spirits.
ENGLISH
15