Example: Programming An Email Alert To Be Sent When Movement Is Detected - avidsen IPC384-Mx Bedienungsanleitung

960P WIFI OUTDOOR IP CAMERA
Activation/deactivation and sensitivity of the
2
movement detector
Actions to take if movement is detected:
notifi cation, send an email, saving a fi le to the
3
memory card (requires a microSD card [not
included] to be inserted into the camera)
Activation/deactivation
recording to the microSD card and the
4
length of videos (requires a microSD card
[not included] to be inserted into the camera)
Not used on this model
5
Video quality settings and number of frames
per second.
Warning: if you set the video quality too
high with respect to the quality of the internet
connection of your camera and smartphone
or tablet, you may experience choppy video
or loss of connection.
Two streams
6
correspond to the maximum resolution
= "résolution Max", and low resolution =
"résolution faible", which you can select from
the live video display.
Warning: in some cases, a change in camera
resolution will only happen when the app is
restarted. Exit and re-launch the Aviwatch
app if there is a problem.
Confi gure the camera's current WiFi settings
7
If a microSD card has been inserted into the
8 camera, you can reformat it and display its
total and free memory
Setting the date and time stamps on the
9
camera's video
Settings for sending emails in the event of an
10
alert (see the example below)
Settings for saving to an FTP server
11
Restarting the camera remotely / Update /
12
Reset
Camera network information
13
2.2 - Example: programming an email alert to be
sent when movement is detected
To program an alert to be sent when movement
is detected, you need 2 email addresses: the
address of the sender which will be used by
the camera, and the address which will receive
the alerts. The camera uses the username and
password of the sender address to connect and
send the email. Confi guration depends on the
of continuous
can be adjusted: they
D - CONFIGURATION
chosen email provider's settings.
Note: the 2 email addresses can be the same
(you will simply be sending an email to yourself).
In our example, we use
www.gmail.com:
sender-address@gmail.com sends the alerts,
recipient@gmail.com
Both addresses need to have been created
beforehand.
First, go to "Réglages Email" (Email settings):
iOS
receives the alerts.
11
1
2
3
4
5
6
7
8
9
10
FR FR
13