Werbung
J5 – Gauge Connector
This connector is used to connect the "EyeSys Mini-IMG" gauge with
its extension cable (see orderable parts table). The pressure can be
read via serial line (WIN. 224) or by REMOTE I/O on Programmable
Analog Out (in this case, the controller replicates the signal coming
from the gauge).
Figure 13
The Mini-IMG gauge is intended for high vacuum use; there-fore, with a
NOTE
pressure above 50 mTorr, the signal is misinter-preted and a "false" pressure is
displayed. Use a transition gauge to check whether the reading is effectively
below 50 mTorr.
TwisTorr 84 FS AG Navigator Controller User Manual / 87-901-038-01
J5 Gauge Connector
Technical Information
J5 – Gauge Connector
159/192
17
Werbung
Kapitel
