Techly I-ALARM-KIT001 Installationsanleitung Seite 9

Comments
Select the phone or SMS number you want to edit, type in the phone number and confirm with
the key "Enter". Use the key " " to clear.
5 phone numbers and 5 SMS numbers can be stored in the control panel.
The LCD screen displays "01/10" (at the left), which indicates the number of the remote control
you are about to connect (01 is the current remote control, 10 is the total number of remote
controls you can connect), and "30" (at the right), which indicates the time remaining to connect
the remote control. Press any key on the keypad or remote control, you hear one beep: the
connection is successful.
Once the remote control has been added, the countdown starts over from 30 so that you can
register another remote control in control panel (up to 10 remote control can be registered in
the control panel). Press Esc to exit.
Enter the number of the Remote Control you wish to delete and press "Enter".
The LCD screen displays "01/50" (at the left), which indicates the number of the RFID tag you are
about to connect (01 is the current RFID tag, 50 is the total number of tags you can connect), and
"30" (at the right), which indicates the time remaining to connect the RFID tag. Swipe the RFID
tag in front of the RFID reader, you hear one beep: the connection is successful.
Once the RFID tag has been added, the countdown starts over from 30 so that you can register
another RFID tag in control panel (up to 50 tags can be registered in the control panel). Press
Esc to exit.
Enter the number of the RFID tag you wish to delete and press "Enter".
Select the sensor type you wish your sensor to be assigned to (Normal Sensor, 24 Hour Sensor,
Delay Sensor, or Home Sensor), press "Enter" to confirm. For more information on zone setup,
please refer to page 14 of this manual.
The LCD screen displays "01/99" (at the left), which indicates the number of the sensor you are
about to connect (01 is the current sensor, 99 is the total number of sensors you can connect),
and "30" (at the right), which indicates the time remaining to connect the sensor. Trigger the
sensor, you hear one beep: the connection is successful.
Once the sensor has been added, the countdown starts over from 30 so that you can register
another sensor in control panel (up to 99 sensors can be registered in the control panel). In such
case, the sensor will be added to the same zone. Press Esc to exit.
Enter the number of the sensor you wish to delete and press "Enter".
Trigger the sensors you have previously connected to the control panel. You hear 1 beep, the
LCD screen displays the signals that have been respectively sent by each sensor triggered.
Make sure all the sensors you have triggered are mentioned on the LCD screen. Press "Esc" to
exit the test mode.
This mode enables you to test if the sensors have been connected successfully to the control
panel.
www.techly.com 9