Techly I-ALARM-KIT001 Installationsanleitung Seite 5

Mount the Control Panel
Before mounting the control panel on the wall, make sure the reception of the
GSM signal is sufficient.
Fix the wall-mounting bracket on the wall with screws. Wedge the panel on the
bracket, make sure they fit well.
Basic Operations
Arm the System
Press the Arm button " " on the control panel. The control panel beeps once:
the system is armed. The LCD display indicates "Armed" and the Arm icon on the
control panel is lit.
Note
If the Entry / Exit Delay is activated, all zones except the 24h zone will be armed
after the delay set (refer to the instructions on page 10 of this manual "Entry
/ Exit Delay").
Disarm the System
Type your user code and press the Disarm button " " on the control panel. The
control panel beeps twice: the system is disarmed.
Home Mode
Press the Home button " " on the control panel. The control panel beeps once: the
system is armed in Home Mode.
All the sensors assigned to the Normal zone are armed. The sensors assigned to
the Home zone are disarmed.
Emergency Mode
Hold the "# " button for 3 seconds. The alarm is triggered immediately and
SOS
the siren rings out. At the same time, the control panel dials the stored phone
numbers.
www.techly.com 5