Techly I-ALARM-KIT001 Installationsanleitung Seite 25

Wireless Motion Detector
Design
1. LED indicator
2. Detection window
3. Bracket
PCB Layout
Antenna
*Tamper switch
When the alarm system is armed, the tamper switch will trigger the alarm if the
case is opened.
**Infrared sensor
Detects the infrared rays released by human body motion. Do not touch the
surface. Keep the surface clean.
1
2
3
LED working
indicator
www.techly.com
LED indications
Blinks continuously: self-testing
Blinks once: an intruder is detected
Blinks twice: self-testing is complete;
entering working mode.
Blinks once every 3 seconds: under-
voltage indication, the batteries must
be replaced. (You will be informed by
SMS when the batteries are low if the
motion detector is registered in the
control panel.)
Alarm zone
setup
Tamper
switch*
Infrared
sensor**
AA 1.5V LR6
25