Techly I-ALARM-KIT001 Installationsanleitung Seite 24

Mute Mode
Press the Home Mode button " " and
then the Arm " " or Disarm " " button
immediately after. Doing so, the control
panel does not beep when you arm or
disarm your system.
Emergency Mode
Regardless the status of the system,
the alarm is triggered when the SOS
button "SOS" is pressed on the remote
control.
At the same time, the control panel
sends a notification by SMS
SOS", 01 being the remote control's
number) and dials the pre-stored
phone numbers.
Register in the control panel
Refer to the instructions in the table on page 8 of this manual
Specifications
Power supply
DC 3V (CR2025 button battery x1)
Static current
≤10 uA
Operating current
≤7 mA
Transmission distance
≤ 80 m (in open area)
Radio-frequency:
433MHz (±75KHz)
24
("RC-01
Housing material
ABS plastic
Operating conditions
Temperature: -10°C ~ +55°C
Relative Humidity: ≤80%
(non-condensing)
Dimensions
57 x 31 x 11 mm
"Remote & Keypad".