Techly I-ALARM-KIT001 Installationsanleitung Seite 26

Usage
Open the case and remove the battery
activation strip. Self-testing will start for
30 seconds.
When the sensor is in operation, if it
is triggered more than twice within 3
Connect Button
minutes, it will switch to standby mode to
save power. If no movement is detected
within the next 3 minutes, the sensor
goes back to working mode.
Register in the control panel
Navigate through the menu of the control panel and reach "ADD A NEW" (Wireless
Sensor). Press the Connect button at the back of the motion sensor or trigger
the sensor (by moving in front of it) to register the detector in the control panel.
Installation
Avoid mounting the detector close to windows, air conditioner, heater, refrigerator,
oven, sunshine and places where the temperature changes fast or where the air
stream flows frequently.
If two detectors are installed in the same detection scope, adjust the location to
avoid interferences and false alarms.
Top
Fix the bracket on the wall
with screws and attach the
detector to the bracket.
Adjust the bracket to change
2.2 m
the detection distance and
angle. It is recommended
to mount the detector 2.2 m
from the ground.
Ground Bottom
The detector is more sensitive to cross movements than vertical movements.
26