Maintenance - Felisatti TP517/AS Bedienungsanleitung

6.6 IMPROPER USE
The functions and use of this tool are those exclusively
indicated in this manual.
ANY OTHER USE OF THE TOOL IS EXPLICITLY
FORBIDDEN !
6.7
ATTENTION!
Contact with or inhalation of the processing
dust may be dangerous for the operator and for
anyone who is in the vicinity.
Particular care must be taken when smoothing
wood or surfaces painted with lead paint due to the
dangerous dust produced.
It is recommended to use safety goggles
and anti-dust masks.
7
Regular inspection reduces the necessity for
maintenance operations and will keep your tool in
good working condition. The tool bearings are life-long
lubricated. The motor must be correctly ventilated
during tool operation. For this reason avoid blocking
the air inlets with hands. After use, disconnect the tool
from the power supply and clean carefully.
7.1 DISPOSAL
At the end of the machine's working life, or when it
can no longer be repaired, ensure that it is disposed
of according to the standard regulations of the
country in which it is being used, and that the disposal
operation is carried out by specialized personnel
following authorized guidelines.
In all circumstances:
- Do not abandon in the environment;
- Do not dispose of together with solid urban waste
products;
- Contact the special recycling centers.
8 PARTS REPLACEMENT
ATTENTION!
Disconnect the plug from the power supply
socket before replacing any parts.
8.1 BRUSHES
The brushes must be replaced after approx. 150-200
working hours, or if they are less then 5-6 mm in length.
ATTENTION!
For correct tool operation always change the
brushes in pairs, not separately. The use of
original Felisatti spare parts is recommended.
ATTENTION!
This operation should only be performed by
anauthorized service center.
ATTENTION: After itting new brushes allow the
motor to run idle for 5 minutes.

MAINTENANCE

8.2 REPLACING THE POWER SUPPLY CABLE
Check that the power supply cable is in good
condition, if not have it replaced by an authorized
service center.
DECLARATION OF CONFORMITY
We hereby declare, under our sole responsibility,
that the FELISATTI brand products described in
this manual comply with the following standards or
standard documents:
directives and following modiications, with 2006/95/
EC, 93/68/EEC and, with regard to electromagnetic
compatibility, the tools conform with directive
EEC/89/336, and with standards EN55014.1, EN
55014.2, EN 61000.3.2, EN 61000.3.3 and EN 50366.
Jordi Carbonell
We reserve the right to make technical changes.
EN60745, 98/37/EC machine
Santiago Lόpez