INVENTOR O3MVI32-09WiFiR Benutzerhandbuch Seite 9

Setting Angle of Air Flow
•
Setting horizontal angle of air ow
The horizontal angle of the air ow must be set
manually. Grip the de ector rod (See Fig.B)
and manually adjust it to your preferred direction.
For some units, the horizontal angle of the air ow
can be set by remote control. please refer to the
Remote Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long periods
of time. This can cause water to condense on
the louver blade, which will drop on your oor
or furnishings. (See Fig.A)
When using COOL or HEAT mode, setting the
louver at too vertical an angle can reduce the
performance of the unit due to restricted air
ow.
Do not move louver by hand. This will cause the
louver to become out of sync. If this occurs, turn
off the unit and unplug it for a few seconds,
then restart the unit. This will reset the louver.
ƒ Page 9 „
Caution: Do not keep louver at too
vertical an angle for long periods of
time. This can cause water condensation
to drip on your furnishings.
Fig. A
CAUTION
Do not put your ngers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
De ector rod
Fig. B
ƒPage 9
„