Preset - Bartscher 280PRO Original-Gebrauchsanleitung

5.1.2 Preset

Never place the device in toxic or explosive environment.
•
Never place the device near flammable materials, such as petrol, fat, clothes,
•
liquid gas, paper etc.
Never place the device in wet room / environment, such as e.g. rain or near
•
leaking water etc.
Only authorized personnel may carry out the installation. The device must be
•
installed in compliance with the safety standards for gas supplied devices,
applicable in a given country.
Make sure that there are no objects around or under the gas stock-pot stove which
•
may reduce the volume of the air required for combustion.
The room in which the device is installed, must have the volume of air required for
•
gas combustion according to the applicable regulations. For the appropriate
combustion, the required air supply cannot be lower than 2 m
rated output of the device (see the rating plate on the device).
Remove any flammable materials from the vicinity of the device.
•
Never place the device directly against walls, low walls, furniture or other objects
•
which are made of flammable material. Keep a distance of at least 20 cm at the
sides and at the rear from walls and other objects. Take into account the applicable
fire protection regulations.
If keeping the above mentioned distance is impossible, apply appropriate safety
•
measures (e.g. heat-resistant foil), which will ensure keeping the wall's temperature
within the safe range
Place the device on an even, stable, dry and waterproof and heat-resistant surface
•
near the gas connection.
Before the first use, remove the protective foil from the device. Remove any glue
•
residues from the foil with an appropriate solvent.
CAUTION!
Never remove the rating plate or any warning signs from the device.
- 40 -
3
/h per kW of the