Troubleshooting The Mower - Snapper RDLT Serie Bedienungsanleitung

Troubleshooting the Tractor (Continued)
PROBlEM
Brake will not hold.
Tractor steers hard or
handles poorly.

Troubleshooting the Mower

PROBlEM
Mower will not raise.
Mower cut is uneven.
Mower cut is rough
looking.
Engine stalls easily
with mower engaged.
Excessive mower
vibration.
Engine runs and tractor
drives, but mower will
not drive.
Catcher full alarm
does not sound when
catcher is full.
en
lOOK FOR
Internal brake worn.
Steering linkage is loose. See authorized dealer.
împrop4r t8r4 8nl0t8on.
Front wheel spindle
bearings dry.
lOOK FOR
Lift linkage not properly
attached or damaged.
Mower not leveled
properly.
Blades are damaged.
Tractor tires not properly
8nl0t43.
Engine speed too slow.
Ground speed too fast.
Blades need sharpening. See authorized dealer.
Mower has other
problem.
Engine speed too slow.
Ground speed to fast.
D8rty or 2lo6643 08r ilt4r.
Cutting height set too low. Cut t0ll 6r0ss 0t m0x8mum 2utt8n6 74867t 3ur8n6 irst p0ss.
Engine not up to
operating temperature.
Starting mower in tall
grass.
Catcher assembly not
closing properly.
Mower has other
problem.
PTO not engaged.
Mower has other
problem.
Grass buildup around
lever.
Alarm has other problem. See authorized dealer.
See authorized dealer.
See Check Tire Pressure section.
See authorized dealer.
See authorized dealer.
See authorized dealer.
See authorized dealer.
See Check Tire Pressure section.
Set to full throttle.
Slow down.
See authorized dealer.
Set to full throttle.
Slow down.
See Servicing Air Filter section.
Run engine for several minutes to warm-up.
Start the mower in a cleared area.
Close catcher until latches are engaged. If still not closing
properly, see authorized dealer.
See authorized dealer.
Engage the PTO.
See authorized dealer.
Clean area around lever.
REMEDY
REMEDY
29