Service And Maintenance - Snapper RDLT Serie Bedienungsanleitung

SERVICE AND MAINTENANCE

Safe Handling of Gasoline
1. Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
2. Use only approved gasoline containers.
3. Never remove the gas cap or add fuel with the engine
running. Allow the engine to cool before refueling.
4. Never fuel the machine indoors.
5. Never store the machine or fuel container where there
8s 0n op4n l0m4, sp0rk, or p8lot l867t su27 0s n40r 0
water heater or other appliance.
. N4v4r ill 2ont08n4rs 8ns834 0 v4782l4 or on 0 tru2k 143
with a plastic bed liner. Always place containers on
t74 6roun3 0w0y 5rom your v4782l4 145or4 ill8n6.
7. Remove gas-powered equipment from the truck or
trailer and refuel it on the ground. If this is not possi-
ble, then refuel such equipment on a trailer with a por-
table container, rather than from a gasoline dispenser
nozzle.
8. Keep nozzle in contact with the rim of the fuel tank or
container opening at all times until fueling is complete.
Do not use a nozzle lock-open device.
9. If fuel is spilled on clothing, change clothing immedi-
ately.
. N4v4r ov4r-ill t74 5u4l t0nk. R4pl024 60s 20p 0n3
tighten securely.
11. Use extra care in handling gasoline and other fuels.
T74y 0r4 l0mm01l4 0n3 v0pors 0r4 4xplos8v4.
12. If fuel is spilled, do not attempt to start the engine but
move the machine away from the area of spillage and
avoid creating any source of ignition until fuel vapors
have dissipated.
13. Replace all fuel tank caps and fuel container caps se-
curely.
Service & Maintenance
1. Never run the unit in an enclosed area where carbon
monoxide fumes may collect.
2. Keep nuts and bolts, especially blade attachment
bolts, tight and keep equipment in good condition.
3. Never tamper with safety devices. Check their proper
operation regularly and make necessary repairs if they
are not functioning properly.
4. Keep unit free of grass, leaves, or other debris build-
up. Clean up oil or fuel spillage. and remove any fuel-
soaked debris. Allow machine to cool before storage.
5. If you strike an object, stop and inspect the machine.
Repair, if necessary, before restarting.
6. Never make adjustments or repairs with the engine
running.
7. Check grass catcher components and the discharge
guard frequently and replace with manufacturer's rec-
ommended parts, when necessary.
8. Mower blades are sharp. Wrap the blade or wear
gloves, and use extra caution when servicing them.
9. Check brake operation frequently. Adjust and service
as required.
10. Maintain or replace safety and instructions labels, as
necessary.
. Do not r4mov4 t74 5u4l ilt4r w74n t74 4n68n4 8s 7ot 0s
spilled gasoline may ignite. Do not spread fuel line
clamps further than necessary. Ensure clamps grip
7os4s irmly ov4r t74 ilt4r 05t4r 8nst0ll0t8on.
en
12. Do not use gasoline containing METHANOL, gasohol
containing more than 10% ETHANOL, gasoline addi-
tives, or white gas because engine/fuel system dam-
age could result.
13. If the fuel tank must be drained, it should be drained
outdoors.
. R4pl024 50ulty s8l4n24rs/mul4rs.
15. Use only factory authorized replacement parts when
making repairs.
. Alw0ys 2omply w8t7 502tory sp428i20t8ons on 0ll s4t-
tings and adjustments.
17. Only authorized service locations should be utilized for
major service and repair requirements.
18. Never attempt to make major repairs on this unit un-
less you have been properly trained. Improper service
procedures can result in hazardous operation, equip-
ment damage and voiding of manufacturer's warranty.
19. On multiple blade mowers, take care as rotating one
blade can cause other blades to rotate.
20. Do not change engine governor settings or over-
speed the engine. Operating the engine at excessive
speed can increase the hazard of personal injury.
21. Disengage drive attachments, stop the engine, re-
move the key, and disconnect the spark plug wire(s)
before: clearing attachment blockages and chutes,
performing service work, striking an object, or if the
unit vibrates abnormally. After striking an object, in-
spect the machine for damage and make repairs be-
fore restarting and operating the equipment.
22. Never place hands near the moving parts, such as a
hydro pump cooling fan, when the tractor is running.
(Hydro pump cooling fans are typically located on top
of the transaxle).
23. Units with hydraulic pumps, hoses, or motors: WARN-
îNì: íy3r0ul82 lu83 4s20p8n6 un34r pr4ssur4 m0y
70v4 sui284nt 5or24 to p4n4tr0t4 sk8n 0n3 20us4
s4r8ous 8n9ury. î5 5or486n lu83 8s 8n942t43 8nto t74 sk8n
it must be surgically removed within a few hours by a
doctor familiar with this form of injury or gangrene may
result. Keep body and hands away from pin holes or
nozzl4s t70t 4942t 7y3r0ul82 lu83 un34r 7867 pr4ssur4.
Use paper or cardboard, and not hands, to search for
l40ks. M0k4 sur4 0ll 7y3r0ul82 lu83 2onn42t8ons 0r4
tight and all hydraulic hoses and lines are in good con-
dition before applying pressure to the system. If leaks
occur, have the unit serviced immediately by your au-
thorized dealer.
24. WARNING: Stored energy device. Improper re-
lease of springs can result in serious personal injury.
Springs should be removed by an authorized techni-
cian.
25. Models equipped with an engine radiator: WARNING:
Stored energy device. To prevent serious bodily injury
from hot coolant or steam blow-out, never attempt to
remove the radiator cap while the engine is running.
Stop the engine and wait until it is cool. Even then,
use extreme care when removing the cap.
13