Husqvarna TXC 250 Bedienungsanleitungen Seite 86

AIR FILTER CHECK (TE)
Turn rear pin (1) counterclockwise, remove the saddle from the
front afstening screw.
Take out the battery (A) and place it sideways on the vehicle.
Remove screw (3) and the filter (4). Separate filter (5) from
frame (6).
1
4
A
3
EN - 30
SPECIFICATIONS - OPERATION - MAINTENANCE
AIR FILTER AND CLEANING (TE)
Wash the filter with a specific detergent then dry it fully (wash
filter with gasoline only in case of necessity).
Plunge the filter in special oil for filters then wring it to drain
superfluous oil.
CAUTION*: Do not use gasoline or a low flash-
point solvent to clean the element. A fire or
explosion could result.
CAUTION*: Clean the element in a well ven-
tilated area, and do not allow sparks or
flames anywhere near the working area.
5
ASSEMBLY (TE)
To ensure tight fit, slightly (C) grease filter edge on side facing
filter housing.
While re-inserting the filter into its housing, make surs that piece
(A) is turned upwards and edge (B) is on the left lower side of
the filter case. Reassemble the parts previously removed (bat-
tery: connect the positive cable first).
CAUTION*: If the element assembly is not
installed correctly, dirt and dust may enter
and the engine resulting in rapid wear of the
piston rings and cylinder.
LATO SUPERIORE UPPER SIDE
C
6
A
B
LEFT SIDE
LATO SINISTRO