Husqvarna TXC 250 Bedienungsanleitungen Seite 77

ENGINE START (TE)
With cold engine, as after a prolonged inactivity of the
motorcycle or in presence of a low external temperature,
proceed as follows:
1) set ignition key (1) in IGNITION position (the buzz that you
hear when you turn the key to IGNITION is caused by the
fuel pump which puts the feeding system under pressure);
2) pull the starter lever (2);
3) pull the clutch lever (3);
4) shift gear pedal (4) in neutral position then release the
clutch control lever;
5) check that the button (5) is in the out position and press it,
followed by the start button (6). Release the starter lever
(2) as soon as the engine can idle. When starting with an
already warmed up engine DO NOT USE the starter. When
a cold engine has just been started, do not increase revs, to
ensure an adequate oil warm-up and circulation.
IMPORTANT
NEVER START WITH DISCONNECTED BATTERY.
1
2
3
6
5
4
3
2
N
1
4
SPECIFICATIONS - OPERATION - MAINTENANCE
5
6
TE
EN - 21