suni SuniCam II Bedienungsanleitung Seite 35

Guide and declaration of the manufacturer - electromagnetic immunity
The SuniCam II is intended to be used in the electromagnetic environment specified
below. The user should make sure it is used in this environment.
Immunity
Trial
Conducted RF 3 Vrms
EN 61000-4-6 150 kHz
to 80 MHz
Radiated RF 3 V/m
EN 61000-4-3 80 MHz to 2.5
GHz
Note 1: At 80 MHz and 800 MHz, the higher frequency band applies.
Note 2: These recommendations may not apply in every situation. Electromagnetic wave
propagation is modified by the absorption and reflection due to the structures,
objects and persons.
a The fixed transmitter field levels, such as the base stations of the radio telephones
(cellular/wireless) and the terrestrial mobile radios, amateur radio, AM, FM, and
TV radio communication cannot be theoretically assessed precisely. To obtain the
electromagnetic environment due to the fixed RF transmitters, a site measurement
should be performed. If a field level measured in the use environment of the SuniCam
II exceeds the compliance levels above applicable, the good operation of the SuniCam
II should be checked. If abnormal operations are proved, some further measures
should be taken, such as reorientation or relocation of the standard device.
b Above the 150 kHz to 80 MHz frequency band, the field level should be lower than 3
V/m.
SCLS-267 Rev A SuniCam II International User Guide Part# 900-0632 29 Dec 2008
CEI 60601
Severity Level
3V
3V/m
Compliance Electromagnetic Environment
Level
Portable and mobile RF
communication devices should not
be used at a distance from the
SuniCam II (including the cables),
lower than the recommended
separation distance, calculated with
the applicable formulas depending
on the emitter frequency.
Recommended separation distance
d = 1,16kMP
d = 1,16kMP
d = 2,33kMP
where
output of the transmitter in
watts (W) by the transmitter
manufacturer and d the
recommended separation distance
in meters (m).
The field levels emitted by the fixed
RF transmitters, determined by an
electromagnetic measurement of
the sitea, should be lower than the
compliance level in each frequency
band.
Interference may occur in the
vicinity of the devices bearing the
following symbol:
Guide
80 MHz to 800 MHz
800 MHz to 2.5 GHz
P
is the maximum rated
34