Inhaltsverzeichnis
Werbung
ELECTROMAGNETIC COMPATIBILITY
Guide and declaration of the manufacturer - electromagnetic emissions
The SuniCam II device is intended to be used in the electromagnetic environment
specified below. The user should make sure it is used in this environment.
Emission Trial
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
EN 61000-3-2
Voltage fluctuations /
Flicker
EN 61000-3-3
Guide and declaration of the manufacturer - electromagnetic immunity
The SuniCam II device is intended to be used in the electromagnetic environment
specified below. The user should make sure it is used in this environment.
Immunity Trial
Electrostatic
discharges
EN 61000-4-2
Far transient
bursts
EN 61000-4-4
Voltage shocks
EN 61000-4-5
Dips, brief
outages and
power voltage
variation
EN 61000-4-11
Magnetic field
with the network
frequency
(50/60 Hz)
U
Note:
is the power voltage nominal value applied during the trial.
T
support@suni.com
Compliance
Group 1
Class B
Not applicable
Not applicable
CEI 60601
Severity Level
± 6 kV when in
contact
± 8 kV in the air
± 2 kV for the
feed cables
± 1 kV for the
input/output
cables
Differential mode
± 1 kV
Common mode
± 2 kV
• <5% U
-
T
for 10 ms
• 40% U
-
T
for 100 ms
• 70% U
-
T
for 500 ms
• <5% U
-
T
for 5 s
3 A/m
Electromatic Environment Guide
The SuniCam II only uses radio energy for its
internal functions. Therefore, its RF emissions
are very low and are not likely to cause
interference with near electronic devices.
The SuniCam II may be used in domestic
premises, including the ones directly
connected to the public low voltage power
distribution network used to supply household
buildings.
Compliance
Electromagnetic Environment
Level
± 6 kV
The floor should be wooden,
concrete or tile. If the floor
± 8 kV
is covered with a synthetic
material, the relative humidity
should be at least 30%.
± 2 kV
The main power supply quality
should be one of a traditional
± 1 kV
commercial or hospital
environment.
± 1 kV
The main power supply quality
should be one of a traditional
N.A.
commercial or hospital
environment.
<5% U
The main power supply quality
T
should be one of a traditional
10 ms
commercial or hospital
<40% U
environment. If the user of the
T
100 ms
SuniCam II device requires it
to continue to operate during
<70% U
T
main power supply outages, it
500 ms
is recommended the SuniCam II
<5% U
device is fed by an inverter or a
T
5 s
battery.
3 A/m
The magnetic field with the
network frequency should be at
a characteristic level of a location
in a traditional commercial or
hospital environment.
Guide
33
Werbung
Inhaltsverzeichnis
