Hints And Tips - Electrolux ESL2460W Benutzerinformation

56 www.electrolux.com
• If you open the door, the display
shows the programme duration that
decreases with steps of 1 minute.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay button again and
again until the display shows the delay
time you want to set (from 1 to 19
hours).
• The delay indicator is on.
3. Close the appliance door. The count-
down starts.
• If you open the door, the display
shows the countdown of the delay
start that decreases with steps of 1
hours.
• When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
Press and hold function buttons (B) and
(C) at the same time until:
• All the programme indicators come on.
When you cancel a delay start, the
appliance goes back to setting
mode. You have to set the pro-
gramme again.

8. HINTS AND TIPS

8.1 The water softener
Hard water contains a high quantity of
minerals that can cause damage to the
appliance and bad washing results. The
water softener neutralises these minerals.
The dishwasher salt keeps the water soft-
ener clean and in good conditions. It is
important to set the right level of the water
softener. This makes sure that the water
Cancelling the programme
Press and hold function buttons (B) and
(C) at the same time until:
• All the programme indicators come on.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
At the end of the programme
When the programme is completed, an
intermittent acoustic signal operates and
the display shows 0.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
• If you do not deactivate the ap-
pliance, after 3 minutes from
the end of the programme:
– All indicators go off
– The display shows 1 horizon-
tal status bar.
• This helps to decrease the en-
ergy consumption.
Press one of the buttons (not
the on/off button), the display
and the indicators come on
again.
Important
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
softener uses the correct quantity of dish-
washer salt and water.
8.2 Using salt, rinse aid and
detergent
• Only use salt, rinse aid and detergent
for dishwasher. Other products can
cause damage to the appliance.