Checking/Replacing Battery Of Easy Dog Receiver Collar; Changing The Contact Points Of Easy Dog Pulse Collar; How To Check That Your Easy Dog Soft Is Functioning Properly; How To Check That Your Easy Dog Pulse Is Functioning Properly - Num'axes EASY DOG SOFT Gebrauchsanleitung

Checking/Replacing battery of receiver collar
To check the condition of the battery, observe the indicator light located on the front of the receiver
collar:
- battery suffi ciently charged: fl ashes slow green.
- weak battery: fl ashes quickly red.
Replace the old battery with a new one (3-V Lithium CR2) (See § First use from new – Fitting the battery
in the EASY DOG receiver collar) then check the receiver collar operates correctly.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be compatible with your
product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.

Changing the contact points of EASY DOG PULSE collar

Two different series of contact points are supplied with the EASY DOG PULSE collar.
The length of the contact points must be suffi cient to have proper contact with the dog's skin, enabling the
device to operate correctly.
If you have a long-haired dog and the short contact points fi tted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).

How to check that your EASY DOG SOFT is functioning properly

You can check that your EASY DOG SOFT is operating correctly at any time.
- Turn "On" the remote control and receiver collar.
- Check the functions of the product as follows:
- when you press the
- when you press the
- when you press the V V V button, the collar must vibrate for as long as the button is pressed
(but 8 seconds max)
- when you press the V button, the collar must vibrate for approximately 1 second.

How to check that your EASY DOG PULSE is functioning properly

You can check that your EASY DOG PULSE is operating correctly at any time.
- Before doing so, make sure the receiver collar is turned "Off" (indicator light off).
- Place the neon test lamp in contact with each of the contact points (by unscrewing them then by screwing
Gb - 28
button, the collar must emit beep sounds
, the high luminosity LED in the collar must light