Short Range Fm Communications (Sm1Xsr Model); Fm Radio Operation - Sens Sensear SM1X Bedienungsanleitung

SHORT RANGE FM COMMUNICATIONS (SM1XSR MODEL)

The SM1xSR provides short range, half duplex, wireless communications with a range of up to
50 meters.
Before Short Range Communication can begin, Short Range FM must be enabled in the System
Setup. Navigate through the menu to Communication Option and Enable Short Range FM.
After it has been "Enabled", SHORT RANGE COMMUNICATIONS MUST BE TURNED ON. Turn
ON Short Range FM by simultaneously pressing "Volume up" and "Volume down". The user will
then receive a message advising that Short Range FM has been turned on.
Frequency The Short Range Communication Frequency can be selected in the System Setup. The
default frequency is 101.3MHz (Region1), 107.9 MHz (Region 2) or 97.0 MHz (Region 3).
All SM1xSR units must be setup on the same frequency if they are to communicate with each
other.
NOTE: A Frequency must be found that is entirely free from interference (eg radio stations) to
ensure best performance.
Region The Short Range Communication Region can be selected in the system Setup. The region
selection determines the appropriate RF Power Level settings for the SM1x SR required to satisfy
regulatory requirements.
Region 1 Australia and New Zealand
Region 2 Western Europe (CE Countries)
Region 3 USA and Canada (FCC Countries)
WARNING: Selecting the incorrect regional setting may violate regulatory requirements. The default
regional setting will be set to the region where the product was purchased.
Volume To adjust the Short Range FM volume the SM1x SR should fi rst be placed in QUIET
Mode. Press and release the "Power" button until QUIET Mode is selected. Press the "Volume Up"
or "Volume Down" buttons to adjust the Short Range FM volume.
Note that SENS volume can only be adjusted when the SM1x SR is in SENS Mode.

FM Radio Operation

SM1xSR units with FM hardware allows the user to tune into broadcast FM in the 88-108MHz
frequency range.
Prior to operation, the FM Radio option must fi rst be enabled in the System Settings. Once this
has been done, FM Radio can be turned on or off by simultaneously pressing the "Multifunction"
and "Power" buttons.
Adjusting FM Radio Volume To adjust the FM Radio volume the SM1x SR should fi rst be placed
in QUIET Mode. Press and release the "Power" button until QUIET Mode is selected. Press the
"Volume Up" or "Volume Down" buttons to adjust the FM Radio volume.
Note that SENS volume can only be adjusted when the SM1x SR is in SENS Mode.
Selecting FM Radio Stations The FM radio is set to a default station of 94.5 MHz. To select a
different station the SM1x SR must fi rst be placed in QUIET mode. Press and release the "Power"
button until QUIET mode is selected.
PRESS AND HOLD THE "VOLUME UP" BUTTON TO SCAN UP IN FREQUENCY TO THE NEXT
FM RADIO STATION. PRESS AND HOLD THE "VOLUME DOWN" BUTTON TO SCAN DOWN
IN FREQUENCY TO THE PREVIOUS FM RADIO STATION.
8