Led Indicators; Charging - Sens Sensear SM1X Bedienungsanleitung

LED INDICATORS

On the Sensear SM1/SM1x(SR) models, there are three LEDs: Red, Green and Blue.
Each LED has the following four modes of operation;
• Off
• Solid on
• Flashing at the normal rate. The normal rate is defi ned as once every 2.5 seconds
• Flashing at the faster rate. The faster rate is defi ned as 5 times per second.
The meaning of LED indicators for Sensear SM1, SM1x and SM1x SR is given in Table 1, below.
Off
Red Battery OK
Green SM1/SM1x turned off. N/A
Blue Bluetooth not
connected to a cell
phone.
Figure 4: LED Indicators

CHARGING

Sensear SM1/SM1x(SR) models are supplied with an AC adapter that operates globally when fi tted
with the appropriate electrical local adapter fi tting.
To charge the Sensear SM1/SM1x(SR), take the following steps:
Step 1
Plug the Sensear AC adapter into an appropriate electrical power outlet.
Step 2
Insert the cable end of the Sensear AC adapter into the DC Power socket on the SM1/SM1x(SR).
While the battery is charged, the Red LED will turn on solid red. When the charging is complete,
the Red LED will fl ash at the normal rate.
Refer to the Section, "LED INDICATORS", for more information.
Solid On Normal Rate
Battery charging Charge complete
SENS processed,
sound active.
Bluetooth "Pairing Bluetooth
Mode" engaged. connected to a cell
phone.
13
Faster Rate
Battery low
SENS processed,
sound muted.
Incoming call,
outgoing call, or
active call.