Getting Started - Sens Sensear SM1X Bedienungsanleitung

GETTING STARTED

To fully utilise the functionality provided by the Sensear SM1, SM1x and SM1x SR models, please
ensure that the Sensear SM1, SM1x and SM1x SR are worn correctly. See Figure 1 for an illustration
of fi tting the SM1/SM1x(SR).
It is recommended that the SM1/SM1x(SR) are fi tted, adjusted and maintained in accordance with
Sensear's instructions; the ear-muffs are worn at all times in noisy surroundings and the cushions
are regularly inspected for serviceability. If these recommendations are not adhered to, the protection
afforded by the ear muffs will be chemical impaired.
The basic functions of getting started with the Sensear SM1, SM1x and SM1x SR are described below.
Powering Up the Product
•
Press and release the "Power" button shown in Figure 1.
•
All the light-emitting diodes (LEDs) will turn on briefl y and the system software will load.
•
The system will play the welcome message, after which it will deliver the SENS processed
sound.
•
The Green LED will fl ash at the normal rate. Refer to Section, "LED INDICATORS", for more
information.
Powering Down the Product
•
Press and hold the "Power" button for two seconds.
• All the LEDs will turn on.
• The system will play the goodbye message, after which it will shut down.
Adjusting the Volume of the SENS Processed Sound
• Press and release the "Volume Up" button to increase the volume.
• Press and release the "Volume Down" button to decrease the volume.
NOTE: SM1/SM1x(SR) models incorporate a volume limiting function which ensures that the
maximum noise exposure is limited according to EN352-4. In high noise environments, the
volume may be automatically reduced to ensure that the noise exposure does not exceed
safe levels. Refer to the Section, "Criterion Levels", for further information.
Warning – The output of the level dependent circuit of this hearing protector may exceed
the external sound level.
Muting the SENS Processed Sound
• Press and release the "Power" button to enter "Quiet Mode".
• The user will still be able to use the two-way radio and answer phone calls, however the user
will not hear the SENS processed sound.
• When in the "Quiet Mode", the green LED will fl ash at the faster rate.
Refer to Section, "LED INDICATORS" for more information.
Restoring the SENS Processed Sound
•
Press and release the "Power" button.
• When exiting the "Quiet Mode", the green LED will return to fl ashing at the normal rate.
IMPORTANT NOTE: The SM1/SM1x(SR) cannot be powered down while charging is taking
place. While the user is in the "System Set-up", or on a telephone call, the volume of SENS
processed sound cannot be changed.
Please refer to the Sections, "BLUETOOTH" and "SYSTEM SET-UP" for more information.
5