Charging The Battery - Silvercrest SAS 82 Gebrauchsanleitung Und Sicherheitshinweise

connected, you can set your personal data. If you wish, you can also
activate / set up alarms, call / text notifications or a move reminder.

Charging the battery

As soon as the battery status display on the Activity Sensor
shows a flat battery, you must charge the battery. To charge the battery,
proceed as follows:
Insert the USB plug on your USB charging cable
port of your switched-on computer.
Connect the magnetic closure of the USB charging cable
your Activity Sensor as pictured. Ensure that the charging cable is
properly attached. The battery will only be charged if this is the case.
You can see the current charge level in the battery status display.
Normally the battery takes about 3 hours to fully charge. As soon
as the device's battery is fully charged, the word "FULL" will appear
in the display.
contacts on the back of the device are wet. If necessary, carefully
pat the charging contacts dry with a cloth.
Do NOT charge the Activity Sensor if the charging
into the USB
2
with
2
GB/IE/NI 13