Display Unit - Yamaha PW45 Bedienungsanleitung

INSTRUMENT AND CONTROL FUNCTIONS
Close
Display angle
adjust bolt
58

Display unit

The display unit offers the following operations and infor-
mation displays.
2 Battery
Check if the rated battery (CR2032) is installed in the rear
Cover
of the display.
Waterproof
If a battery is not installed, or if there is not sufficient bat-
seal
tery power remaining, install a new battery.
Battery
To adjust the time and set the units for distance and
speed, see "Clock and km/mile settings".
TIP
• Make sure that the waterproof seal is installed correct-
ly.
• Please use a new type CR2032 button cell battery (sold
separately).
2 Mounting and removing the display
To mount the display, press the lever on the holder while
sliding the display towards the rear of the bicycle into the
holder. To remove the display, press the lever while sliding
the display towards the front of the bicycle out of the holder.
TIP
• Adjust the display angle by loosening the display angle
adjust bolt. The angle depends on each rider.
• Make sure the display is turned off before mounting or
removing it.