Startup; User Guide; Power Boost; Maintenance - Wallbox PULSAR PLUS Installationsanleitung

Startup

Once the assembly process has been completed your Wallbox Pulsar Plus is ready to be used.
However, please read and review the information detailed below before beginning to operate your
Wallbox Pulsar Plus:
• Do not use your Wallbox Pulsar Plus for purposes not described in the section Product Description.
• Never open the front cover of your charger when it is connected to the power supply.
• Special precautions must be taken with electronic implants. Please contact your medical device
manufacturer to find out the potential effects that the charging process may cause to it.
• Review and confirm all the steps that have been carried out.

User Guide

Follow the User Guide to begin setting up your Wallbox.
• Available at https://wallbox.com
Power Sharing Smart
If your charger is going to be part of a Power Sharing Smart infrastructure, please be sure you have
the instructions to perform this installation. In case of any doubt contact your sales agent.

Power Boost

If your charger is going to be part of a Power Boost infrastructure, please be sure you have the
instructions to perform this installation. In case of any doubt contact your sales agent.

Maintenance

Take some precautions to ensure correct maintenance:
• The are no parts within your Wallbox that the user has to maintain. Only a qualified electrician may open
and modify your Wallbox.
• Make sure that the power supply is turned off before you start cleaning your charger.
• If you want to clean your Wallbox we recommend that you use a soft, dry or damp cloth. Do not use a
spray or direct water stream to clean your Wallbox charger.
• It is mandatory to use the plug holder provided, in order to protect the connector from falling, dirt and
other weather elements.
13