Preparing For Use; Filling The Water Tank - Philips GC7600-Serie Bedienungsanleitung

3 Take the ANTI-CALC cartridge out of its package (1) and pull the
rubber cap from its bottom (2). Place the ANTI-CALC cartridge in
the compartment and press it down until it locks into place (3).
Then close the ANTI-CALC cartridge compartment lid.
Note: Some water droplets may fall out of the ANTI-CALC cartridge when you
place it into the compartment. This is normal and the water is harmless.

Preparing for use

Filling the water tank

- Fill the water tank before every use or when the water level in the
water tank drops below the minimum level. You can refill the water
tank at any time during use.
Make sure you only use one of the 3 types of water mentioned below
-
to fill the water tank:
1 Tap water
The ANTI-CALC cartridge filters scale particles from tap water. The scale
content in the filtered water is regularly monitored by an electronic sensor.
This sensor informs you when the cartridge needs to be replaced.
2 Demineralised water
You can safely use demineralised water in your steam generator. Make sure
that the ANTI-CALC cartridge is always in place, as the cartridge serves as
a link between the water tank and the iron. When you use demineralised
water, the ANTI-CALC cartridge is not used and therefore replacement of
the cartridge is not necessary.
3 Descaled water from the IronCare
The IronCare removes scale from tap water to ensure optimum
performance for your iron. For more information,
go to www.philips.com/ironcare.
Caution: Do not use perfumed water, water from a tumble dryer,
rainwater, vinegar, mineral water, magnetically treated water (Aqua+),
water from a drinking water filter, starch, descaling agents, ironing aids,
salt or chemicals in the water tank. These types of water have been tested.
They are not suitable and may even cause damage to the appliance. If you
use any of these types of water, your guarantee becomes invalid.
1 Open the filling funnel lid.
ENGLIsh
7