Werbung
REMOVAL OF THE CARRIAGE
REMOVAL OF THE CARRIAGE
- Hold the carriage in position with lifting equipment as shown in figure A.
- Remove the circlips retaining the tilting cylinder's shaft plate and then expel the shaft (Item. 1
Fig. B)
If there is an accessory fitted, hold the carriage in position with weges (risk of tipping
over).
- Remove the retaining screw from the carriage shaft plate and then expel the shaft
(Item. 2 Fig. B).
- Remove the carriage.
If the "hydraulic accessory locking system" option is fitted, disconnect the hoses
connecting the locking cylinder.
Fig. A
Fig. B
14
2
1
Werbung
