Connections - Omnitronic CM-860 Bedienungsanleitung

Please note: when using this speaker-system in public or industrial areas, a series of safety instructions
have to be followed that this manual can only give in part. The operator must therefore inform himself on the
current safety instructions and consider them.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use spray cleaners in order to clean the faders!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

4. CONNECTIONS

• Install the device on a plane surface.
• Make sure that the power switch is set to OFF. Before you connect the devices, all units have to be
switched off.
• In order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
• You can connect up to 3 amplifiers to the CM-860. The output signal of the Master 1-signal can be adjusted
via the Master 1-fader and the balance-control. The output signal of the Master 2-signal can be adjusted via
the Master 2-control. The output-signal of the Booth-signal can be adjusted via the Booth-control.
• The Master 1-output can either be connected via the RCA-sockets or the balanced XLR mounting-plugs.
Due to the lower interference problems, we recommend to use the XLR mounting-plugs.
• The Master 2-output can be connected via the RCA-sockets. Make sure that the sockets are set properly (L
& R).
• Via the BOOTH sockets, you can either connect monitor active speakers for the DJ-booth or an additional
amplifier for creating a second zone.
• For recording, connect your tape recorder or cassette deck to the REC OUT-sockets. The REC OUT level
will not be influenced by the master fader. You can set the output level with the channel faders, the tone
controls and the GAIN control.
17/41 10006940_V_2_3.DOC