Apc Settings; Plus - Adixen Sensistor H2000-P PLUS Benutzerhandbuch

APC Settings

NOTE! The APC System is not incorporated
in the battery model H2000-C
The Active Probe Control (APC) system
is a programmable controller used to control
valves etc in external probes. Detailed infor-
mation about the APC system can be found
in the Technical Manual and in the respective
probe manual.
Select the main menu APC Settings as
described on page 12.
1. Press Enter
2. Use < and > to choose between:
Probe Type
APC Time A
APC Time B
APC Time C
APC Time D
Measure Button
Purge Level
The timers will have descriptive names rele-
vant for the probe being used.
3. Press Enter. If Enter Password is dis-
played, this means that the setting function
is protected by a password.
See page 27.
4. Choose the desired option or set the
desired value as described in the Technical
Manual.
(5. Press Undo to delete the setting of a value
and revert to previous value.)
USER MANUAL HYDROGEN LEAK DETECTOR - H2000 PLUS
.

PLUS

5
When Measure Button is selected
the left button is dedicated as start
button for active measurement when
e.g. probe AP29 or AP33 is used.
6. Press Save to save a set value. The saved
value will flash to confirm the setting.
Revert to Detection Mode/Analysis
Mode by pressing Esc twice.
APC Settings
Esc < >
1
APC Settings
APC Time A
Esc < >
2 3
APC Settings
APC Time A
Set Pre fill evacuation
10.0 sec
Undo + –
6
4
®
19
GB
Enter
Enter
Save