Display Settings - Adixen Sensistor H2000-P PLUS Benutzerhandbuch

12 USER MANUAL HYDROGEN LEAK DETECTOR - H2000 PLUS

Display Settings

Select suitable Brightness and Con-
GB
trast for the display.
See page 16.
Sensitivity Settings
Select Sensitivity, Auto Range,
Direct Sensitivity adjustment,
Lowest Frequency and
Dead Band. See page 17 and 18.
APC Settings
Active Probe Control and Printer
settings.
See page 19.
General Settings
Various general settings.
See page 20.
The following is applicable to the settings described on this page and
subsequent pages:
- If no setting is made in a menu or its submenus within 60 seconds, the instrument will
revert to the Detection Mode/Analysis Mode.
- All changes in values are valid only when saved using the Save button.
- Use the Undo button to delete a change in value and revert to the previous setting.
Use the Esc button to browse backwards through the menus to the start position Detection
Mode/Analysis Mode.
®
Display Settings
Esc < >
Sensitivity Settings
Esc < >
APC Settings
Esc < >
General Settings
Esc < >
Enter
Enter
Enter
Enter