Change Test Mode - Adixen Sensistor H2000-P PLUS Benutzerhandbuch

Change Test Mode

Select the main menu Change Test Mode
as described on page 11.
1. Press Enter.
2. Select Analysis Mode by pressing Enter
again.
Tip!
To change quickly from Detection
Mode to Analysis Mode or vice
versa, press the right-hand button three
times in succession.
Explanations
In Detection Mode, the signal is displayed in the form of a bar. The length of the
bar varies with the gas concentration.
In Analysis Mode (see page 26), the measured value is displayed in figures. The
default unit is in PPM but it is possible to choose other units, see General Settings
on page 20.
USER MANUAL HYDROGEN LEAK DETECTOR - H2000 PLUS
Esc
Change Test Mode
Esc < >
1
Change Test Mode
Analysis Mode
< >
2
Analysis Mode
0.5
PPM
– Volume +
®
13
GB
Enter
Enter
Menu