Warnings - Jacuzzi delfi Montageanleitung

"Ho" Excessive water temperature
DO NOT ENTER THE WATER
The water temperature has reached or exceeded 44 °C (111 °F). It is
not possible to activate any function.
- If present, remove cover from hot tub.
- If the excessive temperature increase is due to sunlight, add
cold water to the hot tub.
When the temperature has dropped to below 43 °C (109 °F), the
hot tub should re-activate automatically. If it does not, discon-
nect the power supply and contact an authorized Jacuzzi ® ser-
vice centre.
"H2O" Water level too low.
It's not possible to activate the pump.
- Fill with water until the message disappear.
"rPF" Defective temperature probe
DO NOT ENTER THE WATER
It is not possible to activate any function.
- Check that the temperature probe is working, or replace it.
"HPF" Activation of safety thermostat.
It is not possible to activate the electric heater.
The electric heater has been deactivated due to overheating. This
may be due to irregular water flow.
- Try turning the switch up the line from the hot tub off and back
on (system reset). If the signal stays on, contact an authorized
Jacuzzi® service centre.

WARNINGS

Make sure that all users know how to use the hot tub safely.
How frequently you should check water quality depends on
how frequently the hot tub is used.
Ensure that the chemicals used are suitable for use in spas;
chemicals designed for swimming pools must not be used
as treatment of water in swimming pools and spas is very
different.
CAUTION
Only the load-bearing covers are designed to support
weights (max. 200kg), but they must not be subjected to
violent, sudden stresses (jumping, etc.).
Do not sit, walk, or lie on other types of covers (non-load
bearing). Do not deposit objects.
To prevent accidental falls into the hot tub, it is advisable to
install the key-locking system provided with the thermal co-
ver ( 4).
CAUTION
Read and follow all the instructions related to the use and
storage methods for chemical products, keeping strictly
to the manufacturers instructions on the packets.
Never clean the filter when the pump is running. Turn off the
main switch first.
Never start the pump and heater if the water level is not abo-
ve the highest whirlpool nozzles:
Always turn off the main switch when the hot tub is empty.
With the TEST button, periodically check the efficiency of
the circuit breaker installed up the line from the hot tub.
It is a good rule to empty the hot tub regularly (about every 4-8
weeks), in order to ensure a change of water and proceed with tub
cleaning.
If you are away for any length of time, it is advisable to empty the
hot tub, as long periods without carrying out water treatment can
damage the hot tub.
CAUTION
Before emptying, make sure that the chemical additive
values in the water are within the permitted limits.
If in doubt, contact the local authorities.
DO NOT EMPTY THE WATER INTO A SEPTIC TANK.
33