Silvercrest SEMK 105 A1 Bedienungsanleitung Seite 16

Malfunction
The "Ice full"
lamp lights
up .
The "Add water"
lamp and
the "Ice full" lamp
light up .
No ice cubes are
produced .
The ice cubes
produced are too
small .
SEMK 105 A1
Cause
The ice basket is full .
The infra red sensors above
the ice basket are dirty .
The infrared sensors
above the ice basket
are defective .
The ice cube tray in the
rear part of the appliance is
blocked .
The water or ambient temper-
ature is too high .
The cooling system is leaky .
The cooling system is
blocked .
Poor heat dissipation .
The water temperature is too
high .
The ambient temperature is
too high .
Remedy
Remove some ice cubes from the ice
basket .
Clean the infra red sensors with a soft
cloth .
Contact the Customer Service
department .
♦
Check whether the ice cube tray
is blocked, e .g . by an ice cube,
and remove the blockage .
♦
Pull the plug from the mains
socket and plug it back in again,
then restart the appliance .
♦
Make sure that the ambient tem-
perature is no higher than 32°C .
♦
Make sure that the water used is
between 8 and 25°C .
Contact the Customer Service
department .
Contact the Customer Service
department .
Set up the appliance so that it has a
free space of around 20 cm on all
sides .
Make sure that the water used is
between 8 and 25°C .
Make sure that the ambient
temperature is between 10 and
32°C .
GB │ IE │ NI │ CY │ 13 ■