DynaVox VT-80 Bedienungsanleitung Seite 49

on the loudspeaker, as is the polarity. The other end
of the speaker cable assigned to the loudspeaker is
connected here. The loudspeaker cable must be con-
nected to the same terminals: the "+" marked termi-
nal on the amplifier must lead to the "+" marked
connection of the loudspeaker. The loudspeaker
cables are fitted without connectors. Remove an
approximately 1 cm long piece of insulation from
each end of the double cable. Twist the bare strand
to avoid mutual shorts. Rotate the screw of the loud-
speaker clamp counterclockwise to open the clamp
contacts and insert the bare wire end into the clamp
hole. Now turn the screw connection of the loud-
speaker clamp clockwise again in order to tighten
the wire in the loudspeaker clamp. You can check
that the cable is correctly seated by pulling it lightly.
In case you use pre-assembled speaker cables with
4 mm banana plugs, simply plug them into the bana-
na holder of the loudspeaker clamp. Make sure that
the polarity is correct.
Connection of the mains cable
Lastly, connect the double-groove plug of the power
cable to the double-groove power supply socket
(22) of the amplifier. Plug the power cord into an
electrical outlet that is supplied with a suitable vol-
tage (230 V / 50 Hz). Make sure that the plug in the
item, as well as in the electrical outlet are secure.
Do not turn the unit on until the volume control (2)
has been adjusted to the minimum volume.
49