Installation Guidance - Sharp UJ-GC20E Bedienungsanleitung

INSTALLATION GUIDANCE

Connecting the car adapter and installing the unit
Insert the car adapter into the accessory socket and connect the USB
plug to the car adapter.
Note
• Be sure to remove any dirt from the
accessory socket. Failure to do so
could cause faultily contact or fi re.
1
• The car adapter has 2 USB ports, one of which the Plasmacluster Ion
Generator (UJ-GC20E) uses and another to connect equipment of
1.5A or lower.
• The car adapter (accessory) is for the Plasmacluster Ion Generator
"UJ-GC20E".
It is possible to connect another equipment of 1.5A or lower while the
Plasmacluster Ion Generator is connected. However, in this case, the
normal operation of the additional equipment is not guaranteed.
• The car adapter and/or connecting section could be hot while in use
and/or right after use.
Adjust the angle of louver
and put the unit in the cup
holder.
2
Approx. 55°
E-5
Car Adapter
Accessory
Socket
USB Plug
Approx. 20°