Malaguti F10 Bedienungsanleitung Seite 109

5.11.3 CRUSCOTTO
• Odometer clock light
Light bulb 2V ‑ 2.2W
Light bulb 2V ‑ .2W
• Fuel clock light
Light bulb 2V ‑ .2W
Replacing light bulbs
• Loosen the screws (V‑Fig.26).
• Remove the top section of the instrument board
(A‑Fig.26).
• Take out the lamp socket of the relative part
(P‑Fig.26).
• Remove the light bulb to replace, which is pressed
into its seat, and fit a new, identical light bulb.
It is essential that warning lights (especially
indicator lights) located on the dashboard always
operate correctly. The information they give can
prevent the risk of damages ‑ possibly serious
ones.
V
A
P
Fig.26
5.11.4 TAIL LAMP (with stop light)
AND REAR TURN INDICATOR
• Parking light + stop light
Bulb 2V ‑ 2/5W (P2/5W)
• Rear turn indicator
Bulb 2V ‑ 0W (R0W)
Note: visually check if the stop light works properly,
by pulling one of the two brake levers.
The rate at which the turn indicator warning light
on the instrument board flashes will increase
to signal that one of the four indicators is not
working.
Replacing light bulbs
• Remove the cover by loosening the screws
(V‑Fig.27).
• Replace the lamp + stop (L‑Fig.27) or turn indicator
(A‑Fig.27) light bulb.
• Fasten the cover.
L
V

2
3
4
5
6
ENG
A
Fig.27
3