Troubleshooting - HP Designjet 3D Removal System Einführende Informationen

Troubleshooting

Table 3 Troubleshooting
Problem
No power
Water has not fully
drained from the clean-
ing tank
Models not clean
The system is leaking
Yellow flashing process
error LED
Red flashing process
error LED with cycle
length LEDs as shown:
Recommendation
Verify that the power cord is securely plugged in.
Verify that the power switch is in the ON position.
Verify that AC power is present at the power outlet.
Verify that the strainer and cleaning tank drain are not clogged.
Verify that the drain hose is not clogged.
Verify that there are no kinks in the drain hoses.
Make sure the system is at least 20 cm (8 in.) above the drain hose dis-
charge.
Make sure that no section of the drain hose is higher than the drain
hose discharge.
Verify that the power cord is securely plugged in.
Verify that the power switch is in the ON position.
Verify that AC power is present at the power outlet.
Make sure all the contents of the specified number of cleaning agent
bag(s) is used.
Make sure the correct cleaning tank level is selected.
Make sure the correct cycle length is selected.
Repeat the cleaning cycle.
Make sure the model basket is used to submerge models in the clean-
ing solution and the correct lid position is selected.
Verify that the inlet and drain hose connections are tight.
Make sure the system lid is fully closed.
If recovering from a power loss, press the cancel button.
Verify that the water is fully turned on.
Power cycle the ON/Off switch at the back of the system to reset. Call
Customer Service if the problem persists.
8