HP Designjet 3D Removal System Einführende Informationen Seite 10

Problem Recommendation
Red flashing process Verify that the drain hose is not clogged.
error LED with cycle
Verify that there are no kinks in the drain hoses.
length LEDs as shown:
Make sure the system is at least 20 cm (8 in.) above the drain hose dis-
charge.
Make sure that no section of the drain hose is higher than the drain
hose discharge.
Power cycle the ON/Off switch at the back of the system to reset. Call
Customer Service if the problem persists.
Red flashing LED with Power cycle the ON/Off switch at the back of the system to reset. Call
progress LEDs other Customer Service if the problem persists.
than shown above.
9