Quick Start - HP Designjet 3D Removal System Einführende Informationen

Quick Start

Before proceeding, make sure the HP Designjet 3D Removal System Site Preparation Guide checklist has
been successfully completed. Also, make sure all the steps have been correctly followed as described in
the HP Designjet 3D Removal System Assembly Instructions. Consult your area's requirements regarding
the disposal of the HP Designjet 3D Removal System effluent prior to use. A permit or form of pre-
treatment may be required in your area.
The HP Designjet 3D Removal System is specifically developed to provide efficient removal of support
material from models built with HP Designjet 3D printers. Other models should not be cleaned and may
damage the system.
1. Power on the system using the On/Off switch just above the power cord receptacle on the back of the
system.
2. Place model(s) in the model basket and adjust the lid position.
The model basket lid ensures the models remain submerged during the cleaning process. The lid can
be adjusted to two heights.
• Use the upper lid position for larger models > 8.89 cm (3.5 in.).
• Use the lower lid position for smaller size models ≤ 8.89 cm (3.5 in.).
• Many models may be cleaned at one time as long as they are submerged during the cleaning
process with the model basket lid in either position.
Upper Lid Position Lower Lid Position
4