HP Designjet 3D Removal System Einführende Informationen Seite 8

7. Press the start cycle button. The system lid will lock and the cleaning cycle will begin.
Progress LEDs.
When the cleaning cycle is started, all the progress LEDs are illuminated in yellow. Each progress LED
from right to left will turn off as the cycle time progresses. When the cleaning cycle is complete, the
left-hand progress LED will turn from yellow to green.
Cancel Button
To cancel the cleaning cycle at anytime, press the cancel button on the control panel. The system will
stop and drain the cleaning tank. Before the system completely turns off, the cleaning tank may refill
with water for a final rinse (depending on where the system is in the cleaning cycle) and then drains
again. After the cleaning tank has drained, the lid unlocks so the model basket can be removed. The
drained solution cannot be reused. Models may not be fully cleaned if you cancel the operation.
Process error LED
A flashing yellow process error LED indicates a warning. See "Troubleshooting" on page 8 for
details.
A red process error LED indicates that the system is experiencing an unrecoverable error. See
"Troubleshooting" on page 8 for details.
7