Before You Start; Making Juice - Vitek VT-1636 ST Die Betriebsanweisung

EnGLISH
purpose of repair, please, apply to a certified
service center.
• Store the device in dry, cool, inaccessible for
children place.
• The device is designed only for household
use, any commercial use of the juice extractor
is not allowed.

Before you start

• Remove the device out of the package.
• Before switching the device for the first time,
make sure that working voltage of the device
corresponds to electrical mains voltage.
• Thoroughly clean all detachable parts,
which will be in contact with products, and
dry them.
note: Be careful when holding the filtergrater,
the grater has a sharp surface.
• Wash vegetables/fruit, cut them into pieces,
which can easily come through the juice
extractor cover neck.
• During squeezing of juice from "stone" fruit
(e.g. cherry, peach etc.), remove stones from
fruit.

Making juice

• Put the juice extractor on flat dry and stable
surface.
• Before assembling make sure that the device
is switched off and disconnected from
electrical mains.
• Install the juice collector (5) on the motor
module (8).
• Install the filtergrater (4) in the juice collector
(5).
note: in case of finding of mechanical damages
stop using the filtergrater.
• Install the cover (3) on the juice collector and
fasten it with the help of the clamp (7).
• Install the pulp container(10).
• Connect the mains cable plug to socket.
• Switch on the juice extractor by setting the
switch (9) to position "1" (low speed) or
position "2" (high speed).
note:
 "low speed" – for squeezing of juice from soft
vegetables/fruit (tomatoes, pears, strawber-
1636.indd 4
ries, oranges, plums, grapes, pumpkin, on-
ion, cucumbers etc.).
 "high speed" – for squeezing of juice from
hard vegetables/fruit (artichokes, carrot,
apples, pepper, beet, potatoes, pineapples,
marrow, celery, spinach, dill, leek etc.).
Attention! During treatment of products caus-
ing additional load to the motor (viscous and/or
hard products), to avoid motor stoppage in the
process of operation and its further failure, it is
recommended to use high speed for squeezing
of juice (position "2").
• The juice extractor will switch on only if all
detachable parts are correctly installed, and
the cover (3) is fastened with the clamp(7).
• Start loading products only with motor
running.
• Gradually lower precut pieces of vegetables
and fruit into the cover neck (2) and slightly
push them with the pusher (1). Do not apply
to much load to the pusher, as this can impair
quality of the resulted juice and even stop
rotation of the filtergrater (4). The more
slowly vegetables and fruit are treated, the
more juice you will get.
• It is not allowed to put fingers and other
objects into the cover neck (2).
• During operation,
condition of the filtergrater (4) against
clogging of the filter mesh with pulp, and if
necessary, clean the filtergrater (4).
• If the filter mesh is clogged with squeezed
product, to avoid a failure of the device,
switch it off and clean the filtergrater (4).
• Watch over filling up of the pulp container
(10). If the container is filled up, switch
the juice extractor off, take the cable plug
out of socket, and remove pulp from the
container.
ATTEnTIOn: The maximal allowable con-
tinuous operation time should not exceed
2 minutes with subsequent break of at least
3 minutes.
During the operation clean the lid and the grating
filter from the pulp periodically. Maximal allowed
amount of vegetables/fruit is 2 kg. After that
switch the unit off and clean the lid and the
grating filter from the pulp.
4
periodically check
16.12.2013 12:01:31