List Of Operating Parameters - De Dietrich KALIKO Essentiel ETWH180E Installations- Und Wartungsanleitung

Fig.132
Parameter
EEV
UE : xx
X
X
DI : XX
P1
P2
P3
t1
t2
t3
YY-MM-DD
7659610 - v02 - 08032017
3. Press the arrows to show the measured values one by one (refer to
4. Exit the measured values menu by waiting for 10 seconds.
9.3.2
Description
Water temperature in the domestic hot water tank
Measured room temperature
Evaporator temperature
Intake temperature
Discharge temperature
Water temperature difference between the set point and the
restart
Electronic pressure release valve position
UE : Operating indication:
for the compressor
for the immersion heater
for the compressor and immersion heater combined
xx : Electrical power consumption
Operating mode
1 = ECONOMY MODE = Economic mode
2 = HYBRID MODE = Hybrid mode
4 = OPT.BACKUP = Peak rate/off-peak rate optimisation
mode
8 = OFF mode
:
Fan speed:
F0 = OFF
F1 = Slow
F2 = Moderate
F3 = Fast
Anti-legionella function:
DI : -- : Function not active,
DI : 65 : Anti-legionella temperature of 65°C,
DI : 70 : Anti-legionella temperature of 70°C
Total energy consumption for the thermodynamic water heater kWh
Energy consumption for the heat pump over the last 24 hours
Energy consumption for the immersion heater over the last 24
hours
Total runtime for the thermodynamic water heater
Runtime for the heat pump
Runtime for the immersion heater
Last error code
Second error code
Third error code
Software version
the table below).

List of operating parameters

9 Settings
Unit
°C
°C
°C
°C
°C
°C
A
Wh
Wh
hours
hours
hours
en
219