OHAUS TD52 Serie Bedienungsanleitung Seite 8

Discrete i/o-schnittstelle

Vorschau ausblenden Andere Handbücher für TD52 Serie:

Verfügbare Sprachen

EN-6

Disassemble the cable gland by loosening the cap nut and removing the rubber seal.

Pass the relay output through the cap nut, then spread the rubber seal and place it over

the cable. Now pass the cable through the body of the cable gland.

Install the relay board. Secure it with 2 screws. (Note: boss post is 5 and 7.)

Connect the cable to the relay board 12 pin connectors. Put the relay cable through the

M25 hole. Connect it to the 3 pin and 6 pin connectors.

M25 Gland

Cap Nut

Relay Output Cable

Boss Post 5, 7

Td52p Td52xw